Car Dent Puller Kit, Painless Dent Removal Kit with Adjustable Dent Lifter, Hot Glue Gun, Dent Puller for Small Dents & Big Dents,Reusable Car Body Dent Repair Tool (Small & Big dent)

Dent puller is an ideal tool to remove dents and hail damage of automobiles. Our paint-free dent repair kit is suitable for any car dent, repairing door door and hail damage and other dents. Effectively and safely repair dents, door holes and hail damage on metal surfaces such as automobiles, motorcycles, refrigerators and washing machines. The original paint is not damaged.

1. Clean the dent with a clean dam cloth and mark it with a marker pen.

2. Load the specialized glue into the hot melt glue gun, andplug it into the electrical outlet to warm up for about 3-5 minutes. (This dent repair kit is come with glue gun and glue tabs, There is a switch on the handle of the glue gun, which needs to be turned on and preheated for 5-8 minutes before the glue flowing out can be used.)

3.Forbridge repair tools, there are gaskets of 56 different sizes for you to choose. Choose a suitable gasket and evenly apply the glue on the gasket by using glue gun ( Notes: Large dents require large gaskets; the larger the gasket, the greater the traction; apply the glue shot by the hot melt glue gun onto the tab as soon as possible and stick it to the dent quicjiy.)

4. Once the glue is applied, stick the gasket into the dent position quickly, and gently press it until the spexialixed glue is glued. (The glue on the tab is in good viscosity for using under the state of a little warm.)

5. Align the hole at the center of bridge to the firmly sticked gasket, insert the nut into the gasket rod and tighten it firmly until the dent removed by pulling.

6. Once the dent is repaired, twist off the nut, remove the bridge and gasket,and then spay the alcohol onto the residual glue on the body, remove the residual glue on the opposite side with spatula. The repair is completed. (Tip: Patiently repeating the repair steps is necessary to achieve perfect repair effect.)

Installation Steps：

1. Make the T-shape and the rod closely connected.

2. Install the T-shaped and the long rod.

3. Install the slide hammer and the spring.

4. Rotate the T-bar puller interface and the long rod.