X AUTOHAUX Inboard Propeller Puller C Clamp Puller for Ski & Wakeboard Surf Propellers fits 3/4" to 1-1/8" Shaft

Feature:

• Works on 3/4" to 1-1/8" shaft diameters.
• These make the puller tough and sturdy enough to achieve a good anti-corrosion and anti-rust effect.
• Designed to remove 2, 3, and 4 blade propellers on inboard shafts. These tools have fine thread screws to enable a strong pulling force with little effort.

Installation:

• Remove the cotter pin. Loosen the prop nut twice (do not remove the nut).
• Back out the prop puller bolt to allow for installation of the puller. Put the puller between the forward end of the prop hub and aft of the strut.
• Tighten the puller bolt clockwise with a wrench. Don't tighten too much.
• After the puller is firmly in place and the puller bolts are tightened, tap the opposite end of the puller with a hammer. Steps 3 and 4 May need to be repeated.
• When reinstalling the propeller, a thin layer of grease or anti-tightening film can be applied to the shaft/hole taper, but do not apply too much. Also, do not tighten the support nut too much.

Package Includes:

• 1 x Inboard Propeller Puller